Sequential Play - Panasonic SL-CT485 Operating Instructions Manual

Sequential Play (Fa
VOLUME
Increase
Track number in play
S-XBS
i MNI
t UUI
Elapsed playing time of each track
3.5 mm (1/8 in.) stereo `
Follow steps 1-5.
In step 2: Connect the stereo headphones/earphones and wired remote control (SL-CT485) to the headphone jack
[Q] . (Plug in firmly.)
In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when
pressed while the level is displayed. If any other display is shown, it changes to show the current level.
(The volume returns to 10 when you disconnect the power source.)
Play stops automatically when all the tracks have been played.
èlf the unit has been connected to the car audio system, set this unit's volume to 10, then adjust the volume level on
the system.
Press during play. | Total playing time
To stop play l
'
i
L
Total number mm
of tracks ì grt
Stop mode
Press during stop mode.
To turn off the
unit OPR
OFF
Press during play.
(Press [Mtd] twice to skip to the
beginning of the previous track.}
Backward
<<
(=)
PZA
ti
ve
; ®During program play (page 4), these buttons are
i used to skip forward or backward through the
1 programmed sequence of tracks.
i eYou cannot skip to tracks that have been played
l in random or random repeat play (page 4).
i
L
L
I
l
L
I
Skipping
tracks
Forward
Press and hold during play.
ə During program play, 1-track repeat play, random
play and random repeat play (page 4), search op-
eration is limited to the current track only.
Searching
through tracks
For your reference:
"no diSl" indication f
This indication appears for about 30 seconds if [P 10] (main unit) or [B/) (remote control) is pressed when no disc
is loaded in the unit or if the disc is not properly secured.
"noen" indication
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when
the unit is powered off.)
Label must face
upward.
Resume function
The player stores the track where you stopped play and
if you press [> H] (main unit) or [W/» ) (remote control),
play resumes from the beginning of the track.
The resume function is canceled (play starts from the
first track) if you open the lid when the unit is in stop
mode. It is also usually canceled when you replace the
CD while the unit is off.
Tho resume function may work if you replace the CD
while the unit is off.
elf you turned the unit off near the end of the track, play
may resume from the beginning of the next track.
eThe resume function works automatically and cannot
be turned off.
Removing discs
1 Press [H,OPR OFF] to stop play and disc
rotation.
2 Slide [OPEN >] to open the lid.
3 Press [PUSH] to release the disc.
Do not stop the disc by hand or try to ramove it befora it
stops rotating. This can damage CDs.
Never insert foreign objects into the unit.
Auto power off function
If the unit is left in stop mode for approximately 10 min-
utes, the unit powers itself off automatically in order to
prevent the batteries from running down.
(If no disc is loaded in the unit it powers itself off in
about 30 seconds.)
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized" upon completion
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
"Finalizing is a process that enables CD-A/CO-RW players
to play audio CO-R and CD-RW.