Using The Menu Screen - Panasonic NV-GS40 Operating Instructions Manual

2
Adjust by turning the Eyepiece Corrector
(37)
Knob .
(37)
ª Using the LCD Monitor
With the LCD Monitor open, you can also record
the picture while watching it.
1
Put a finger on the [OPEN4] Knob
pull the LCD Monitor
direction of the arrow.
≥The Viewfinder goes off.
(2)
(1)
2
Adjust the LCD Monitor angle according to
the desired recording angle.
≥The LCD Monitor can rotate a maximum of
180o 1 from the vertical position to the
upward direction and a maximum of 90o 2 to
the downward direction. Forcefully rotating
the LCD Monitor beyond these ranges will
damage the Movie Camera.
1180o
Closing the LCD Monitor
Push the LCD Monitor until it is securely locked.
≥Make sure the Card Slot Cover is closed.
ª Adjusting Brightness and Colour
Level
When [LCD/EVF SET] on the [DISPLAY SETUP]
Sub-Menu is set to [YES], the following items are
displayed.
LCD/EVF SET
LCD BRIGHTNESS
[-]||||----[+]
LCD COLOUR LEVEL
[-]||||----[+]
EVF BRIGHTNESS
[-]||||----[+]
PRESS MENU TO RETURN
Before Use
12:30:45
12:30:45 12:30:45
15.10.2003 15.10.2003
15.10.2003
12:30:45
15.10.2003
(1) and
(2) out about 90o in the
290o
LCD Brightness [LCD BRIGHTNESS]
It adjusts the brightness of the image on the LCD
screen.
LCD Colour Level [LCD COLOUR LEVEL]
It adjusts the colour saturation of the image on
the LCD screen.
Brightness of the Viewfinder
[EVF BRIGHTNESS]
It adjusts the brightness of the image in the
Viewfinder.
To Adjust
Press the [PUSH] Dial and select the item to be
adjusted, and then turn the [PUSH] Dial to raise
or lower the number of vertical bars in the Bar
Indication.
≥A larger number of vertical bars indicates
stronger brightness or colour saturation.
To Increase the Brightness of the Entire LCD
Monitor
Set the [LCD MODE] on the [DISPLAY SETUP]
Sub-Menu to [BRIGHT].
≥These adjustments do not affect the recorded
images.
≥For other notes concerning this item, see

Using the Menu Screen

To facilitate the selection of a desired function or
setup, this Movie Camera displays various
function setups on Menus.
1
Press the [MENU] Button
(46)
≥The Menu corresponding to the Mode
selected by using the [OFF/ON/MODE]
(43)
Switch is displayed.
(43)
2
Turn the [PUSH] Dial
Sub-Menu.
≥Turn the [PUSH] Dial
highlightened item.
3
Press the [PUSH] Dial
selected Sub-Menu.
4
Turn the [PUSH] Dial
to be set.
-13-
(46)
.
(38)
WB/SHUTTER/IRIS/
PUSH
MF/VOL/JOG
(38)
to select a desired
(38)
to display the
(38) to display the
(38) to select the item
.
-64-