Attaching The Lens Cap; Attaching The Shoulder Strap - Panasonic NV-GS40 Operating Instructions Manual

ª To Use as a Hand Strap
Using the Grip Belt as the hand strap makes it
easier to handle and carry the Movie Camera. It is
more convenient to use with the Free Style
Remote Controller with Mic.
1
Open the Lock Cover
tabs on both sides 1, press the Lock
Button (19) and detach the Grip Belt.
(20)
1
2
Slide the pad of the Grip Belt.
3
Attach the Grip Belt around your wrist.
≥When putting the Grip Belt back to the Grip Belt
Attachment part, press on the Lock Cover 2 to
be securely locked.

Attaching the Lens Cap

To protect the Lens surface, attach the Lens Cap.
1
Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then
pass the other end through the loop made
by itself and pull tight.
Before Use
(20) by holding the
(19)
2
2
Pass the end of the Lens Cap Cord through
the hole in the Grip Belt Attachment part
and the Lens Cap through the Lens Cap
Cord.
≥The removed Lens Cap can be hooked onto the
Grip Belt. (It is not possible when using as a
hand strap.)
≥When you are not recording, be sure to keep
the Lens Cap attached to the Lens for
protection.

Attaching the Shoulder Strap

We recommend that you attach the Shoulder
Strap before going out of doors to record so as to
avoid dropping the Movie Camera.
1
Pull the end of the Shoulder Strap through
the Shoulder Strap Holder on the Movie
Camera.
2
Fold the tip of the Shoulder Strap, run it
through the Shoulder Strap Length
Adjuster, and pull it.
≥Pull it out more than 2 cm 1 from the
Shoulder Strap Length Adjuster so that it
cannot slip off.
≥Attach the other end of the Shoulder Strap to
the other Shoulder Strap Holder as the same
way.
-11-
1