Panasonic TU-PTA500U Operating Instructions Manual page 23

Mode
4
For an elongated image
4
Panasonic
AUTO
For a 4:3 image
4
NORMAL
NORMAL
4
JUST
4
ZOOM
4
FULL
Note:
The screen size also changes if ID-1 is detected.
Picture
16
Panasonic AUTO
3 9
Image is expanded
Changes in accordance
with the Panasonic
3
AUTO mode setting
(see page 49)
3
16
JUST
3
16
ZOOM
3
16
FULL
3
The display will automatically become enlarged
(depending on the picture source), allowing you to view
the picture at its maximum size.
Notes:
(1) Panasonic AUTO mode is designed to automatically
adjust the aspect ratio to handle a mix of 16:9 and
4:3 program material. Certain 4:3 program material,
such as stock market data screens, may
occasionally cause the image size to change
unexpectedly. When viewing such programs, it is
recommended that the ASPECT be set to NORMAL.
(2) There may be a slight delay for the screen size to
adjust. If a 480p or 720p or 1080i signal is input
during component input signal mode, the controls
will not operate.
NORMAL will display a 4:3 picture at its standard 4:3
size.
JUST mode will display a 4:3 picture at its maximum
size but with aspect correction applied to the center of
the screen so that elongation is only apparent at the
9
left and right edges of the screen. The size of the picture
will depend on the original signal.
ZOOM mode magnifies the central section of the picture.
9
FULL will display the picture at its maximum size but
with sight elongation.
9
ASPECT Controls
Explanation
23