Extension Telephone; Fax Activation Code - Panasonic KX-FP300E Operating Instructions Manual

Extension telephone

If you connect an extension telephone to your unit or the same line, you can receive fax documents using the
extension telephone. You do not have to press
Important:
Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1
When the extension telephone rings, lift the
handset of the extension telephone.
2 When:
— document reception is required,
— a fax calling tone (slow beep) is heard, or
— no sound is heard,
press 9 (pre-selected fax activation code)
firmly.
3 Hang up the handset.
The unit will start reception.

Fax activation code

The fax activation code is required in the following cases;
— to receive faxes using an extension telephone (see above).
— to receive a voice message and fax document in the same call (p. 73). (KX-FP300 only)
Important:
This code should be different from the remote activation ID (p. 73), the auto disconnection code (p. 87) and
remote operation ID (p. 102).
1
Press MENU .
Display:
2 4
Press , then
3
Press START/SET/COPY
4
Press or to select "ON".
If this feature is not required, select "OFF".
5
Press START/SET/COPY
The display will show the pre-selected code.
6
Enter the new code.
This code can be from 2 to 4 digits in length
using 0 – 9, and
7
Press START/SET/COPY
8 MENU
Press .
START/SET/COPY
1.SYSTEM SET UP
1
.
FAX ACTIVATION
.
MODE=ON
.
CODE= 9
.
.
SETUP ITEM [
Receiving Faxes
on the unit.
Extension telephone
Note:
You can change the fax activation code (see
below).
/
Note:
If you subscribe to any special telephone
company services which require a code, all
or part of the fax activation code must be
]
different from the service access code.
The fax activation code should not be set to
"0000".
To EXT jack or
the same line
MENU
START/SET/COPY
83