The Remote Control - Panasonic SC-VK725D Operating Instructions Manual

4
STEP
AM loop antenna
•
Connect the AC power supply cord only after all other connections are complete.
•
Optional antenna connections (
Preparation
Twist and pull off the vinyl tip of the antenna wires.
AM loop antenna
Stand the antenna up
on its base.
Before connecting the AC power
supply cord, set the voltage.
Voltage Selector
Use a flat-head screwdriver to set the
voltage selector on the back of the main
unit to the appropriate position for the
area in which this system is used.
VOLT ADJ
Conserving power
The unit consumes power (
To save power when the unit is not to be used for a long time, unplug it from the household AC power socket. You will need to reset some
memory items after plugging in the unit.
5
STEP
Remote control
R6/LR6, AA, UM-3
RQT8251
8
8
Radio and power supply connections
A A A A A
page 30).
1
220-240V
110-127V
: approx. 0.8 W or
VK725D

The remote control

Batteries
Insert so the poles (+ and –) match those
in the remote control.
•
Do not use
rechargeable
type batteries.
FM indoor antenna
: approx. 0.9 W) even when it is turned off with [f] (main unit: [f/I]).
VK825D VK925D
Do not:
• mix old and new batteries.
• use different types at the same time.
• heat or expose to flame.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
•
use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
7 7 7 7 7 Use
Aim at the remote control signal sensor (A page 10), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
AC power supply cord
FM indoor antenna
Tape the antenna where reception
is best.
Adhesive
tape
1
2