The Radio - Panasonic SC-VK725D Operating Instructions Manual

REW/ / ,
/ /FF
TUNER/BAND
DECK 1/2
DECK 1
DECK 1
Numbered
buttons
TUNER/AUX
, REW/ ,
, /FF
SHIFT

The radio

Manual tuning
1
Press [TUNER/AUX] (main unit: [TUNER/BAND]) to
select "FM" or "AM".
The unit comes on.
Press [(] or [)] (main unit: [REW/ 4 4 4 4 4 / g] or
2
[f/3 3 3 3 3 /FF]) to select the frequency.
Press and hold [(] or [)] (main unit: [REW/4/g] or
[f/3/FF]) until the frequency starts scrolling to start automatic
tuning. Tuning stops when a station is found.
"TUNED" is displayed when a radio station is tuned.
"ST" is displayed when a stereo FM broadcast is being received.
L L L L L If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
Monaural sound is selected and noise reduces when reception is
weak.
Press [PLAY MODE] again to cancel the mode.
"MONO" is also canceled if the frequency is changed.
RQT8251
22
22
The radio
L L L L L AM allocation setting
The step is factory-set to 9 kHz, but you can change it to receive
broadcasts allocated to 10 kHz steps.
1. Select "FM".
2. Press and hold [TUNER/BAND].
STOP
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The minimum
, TAPE
frequency changes and the step is changed.
, DVD/CD
DECK 2 To return to the original step, repeat the above steps.
REC
Note
After changing the "allocation" setting, the frequencies you previously
DECK 2
preset in the memory will be cleared. Preset them again.
Preset tuning
Remote control only
There are two methods of pre-setting stations.
Automatic presetting :All the stations the tuner can receive are
Manual presetting
TUNER PGM Up to 15 stations each can be set in the FM and AM bands.
Preparation:
Press [TUNER/AUX] to select "FM" or "AM".
Automatic presetting
PLAY MODE
Do the following once each for FM and AM.
Preparation: Tune to the frequency where pre-setting is to begin.
, DVD/CD
, TAPE
Press [SHIFT] + [TUNER PGM] until the frequency
changes.
The tuner presets all the stations it can receive into the channels in
ascending order. The last station to be set is then played.
Manual presetting
Pre-set the stations one at a time.
,
1
Tune to the station
2
Press [SHIFT] + [TUNER PGM].
3
While "PGM" is flashing on the display
Press the numbered buttons to select a channel.
Alternatively, press [g, REW/4] or [f, 3/FF] then press
[SHIFT]+[TUNER PGM].
The station occupying a channel is erased if another station is
preset in that channel.
Selecting channels
Remote control only
1
Press [TUNER/AUX] to select "FM" or "AM".
2
Press the numbered buttons or [g, REW/4 4 4 4 4 ] or
[f, 3 3 3 3 3 /FF] to select the channel.
• To select a 2-digit number
e.g. 12: [h10] A [1] A[2].
(main unit only)
preset.
:You can select the stations to preset and
the order they are preset in.
(A see left).