Remote Control Code; To Turn Off Volume Limitation - Panasonic SC-HTB65 Operating Instructions Manual

Dimmer mode
You can turn off dimmer mode and keep the LED
indicators bright.
While pressing and holding [BD/DVD] on
the remote control, press and hold
[s VOL] on the main unit for more than
4 sec to turn off Dimmer mode.
≥ The indicator for the current condition will turn brighter.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is on.
To turn on dimmer mode, repeat the operation above.
After performing the operation, the indicator for the current
condition will be dim.
Auto standby function
With this function turned on, this unit will
automatically switch to standby mode if there is
no signal input and no operation is performed for
2 hours.
To change the setting:
While pressing and holding [DIALOG
LEVEL j] on the remote control, press
and hold [INPUT SELECTOR] on the
main unit for more than 4 sec to change
the setting.
"AUTO POWER DOWN" indicator
P
lights:
Auto standby function is on.
(Factory preset)
"AUTO POWER DOWN" indicator
P
turns off:
Auto standby function is off.
≥ The setting is maintained until it is changed again.
≥ To change the setting again, repeat the operation above.
Others

∫ Remote control code

When other Panasonic devices respond to this
system's remote control, change the remote control
code on this system and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
20
RQT9825
Change the remote control code to code 2:
1 Aim the remote control at the main unit's
remote control sensor.
2 Press and hold [MUTE] and [BD/DVD] on the
remote control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the
code of this system is changed.
P
≥ The setting is maintained until it is changed again.
≥ If the main unit does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace[BD/DVD] with [TV].
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the
volume is set low, it is possible to reduce the
dialog enhancing effect as follows:
While pressing and holding [SOUND] on the
remote control, press and hold [s VOL] on the
main unit for more than 4 sec.
≥ All the indicators will blink once when the clear-mode
dialog effect is reduced.
P
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
To reset the setting, return to the factory preset. (
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you
every time the main unit turns on, for example, it
is possible to turn off this function as follows:
While pressing and holding [MUTE] on the
remote control, press and hold [VOL i] on the
main unit for more than 4 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
P
To reset the setting, return to the factory preset. (
21)
21)