Advanced Operations; Reference - Panasonic SC-HTB65 Operating Instructions Manual

Advanced operations

Audio format indicator
To display the current audio format.
Press and hold [SOUND] for more than
4 sec.
≥ The current audio format is indicated for 5 sec.
"STADIUM" indicator blinks:
Dolby Digital is the audio format.
"MUSIC" indicator blinks:
DTS is the audio format.
"CINEMA" indicator blinks:
PCM is the audio format.
Audio format is not indicated when "BD/DVD" is selected as
the source.
Changing the dual audio
Change the dual audio from main to secondary.
≥ This setting will only work if the audio output
setting on the connected TV or player, etc. is
set to "Bitstream" and dual audio is available in
the audio source.
Press and hold [MUTE] for more
than 4 sec.
"STANDARD" indicator blinks (A):
Main (Factory preset)
"STEREO" indicator blinks (B):
Secondary
(SAP: Secondary Audio Program)
When A and B both blink: Main and
secondary
While the setting is displayed, press
[MUTE] to change the setting.
≥ The setting changes each time [MUTE] is pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
Auto gain control
With this function, you can prevent sudden loud
sounds. The output will be reduced automatically
when the input exceeds a certain level.
Press and hold [BD/DVD] on the remote
control for more than 4 sec.
"STANDARD" indicator blinks:
Auto gain control is on.
"STEREO" indicator blinks:
Auto gain control is off.
(Factory preset)
While the setting is displayed, press
[BD/DVD] on the remote control to
change the setting.
≥ The setting changes each time [BD/DVD] is pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ The setting is maintained until it is changed again.
Using the Dolby Virtual
Speaker effect
Depending on your preference, It is possible to
turn off the 3D surround effect and the clear-
mode dialog effect.
While pressing and holding
[SOUND] on the remote control,
press and hold [VOL i] on the main
unit for more than 4 sec.
"STANDARD" indicator blinks:
3D surround effect and clear-mode
dialog effect is on.
"STEREO" indicator blinks:
3D surround effect and clear-mode
dialog effect is off.
While the setting is displayed, press
[SOUND] to change the setting.
≥ The setting changes each time [SOUND] is pressed.
≥ The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥ This setting will be reset to on when the main unit is turned
off.
≥ When off is selected, the dialog effect level cannot be
adjusted.
19
RQT9825