Remote Control Code - Panasonic SC-HTB550 Operating Instructions Manual

SC-HTB550_RQT9660_mst.book Page 27 Monday, January 30, 2012 4:53 PM
Auto standby function
With this function turned on, this unit can be set to
automatically switch to standby mode if there is no signal
input and no operation is performed for 2 hours.
Press and hold [INPUT SELECTOR]
on the main unit for more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
Auto standby function is on.
PCM indicator blinks:
Auto standby function is off.
While the indicator is blinking, press
[INPUT SELECTOR] to change the
setting.
≥ The setting changes each time [INPUT SELECTOR] is
pressed.
Others
The following settings are unnecessary under
general usage conditions of the system.

∫ Remote control code

When other Panasonic devices respond to this system's
remote control, change the remote control code on the
main unit and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at this system's remote
control sensor.
2 Press and hold [MUTE] and [
control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the code of
this system is changed.
≥ The setting is maintained until it is changed again.
≥ If this system does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
[ ]
steps above, but replace with [TV].
∫ To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, for example, It is possible to reduce the dialog
enhancing effect as follows:
Press and hold [TV] on the remote control and [s VOL] on
the main unit for more than 2 sec.
≥ All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥ Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
∫ To turn off VIERA Link "HDAVI
Control"
When "HDAVI Control" compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
≥ When VIERA Link is turned off the ARC function is not
available. Be sure to connect the optical digital audio
cable. (
1 Press and hold [MUTE] on the remote control
and [s VOL] on the main unit for more than 2
sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on
again.
≥ All the indicators will blink once when VIERA Link "HDAVI
Control" is turned off.
∫ To turn off the volume limitation
If a state of the lowered volume disturbs you every time
this system turns on, for example, it is possible to turn off
this function as follows:
Press and hold [MUTE] on the remote control and
[VOL r] on the main unit for more than 2 sec.
≥ All the indicators will blink once when the volume limitation
is turned off.
] on the remote
The settings of the clear-mode dialog effect, VIERA Link
"HDAVI Control", and the volume limitation remain intact even
if you switch this system to standby mode. To turn these 3
functions back on, this system must be set back to the factory
preset. ( 28)
19)
RQT9666
27