The Radio; Manual Tuning; Preset Tuning - Panasonic SC-VK950 Operating Instructions Manual

The radio

Numbered
buttons
u, i,
2/REW, FF/1
TUNER/
MUSIC P.
CANCEL
Preset channels to make selection simpler. Up to 15 stations can each be set in the FM and AM bands.
Automatic presetting
Tune to the frequency where presetting is to begin (➡ see
above).
Press and hold.
(release when "AUTOCH1" appears)
The tuner presets the stations it can receive into the channels in
ascending order.
When finished, the last station to be set is played.
Selecting channels
For the remote control only
1
Press [TUNER/MUSIC P.] to select "FM" or "AM".
2
Press the numbered buttons or [u, 2/REW] or
[i, 1/FF] to select the channel.

Manual tuning

1
Select "FM" or "AM".
FM AM
VOLUME,
+, –
• Press and hold [t] or [y] until the frequency starts scrolling to start
automatic tuning. Tuning stops when a station is found.
t, y,
SLOW/ "ST" is displayed when a stereo FM broadcast is being received.
SEARCH
If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
To cancel, press [PLAY MODE] again.
The mode also cancels when you change the frequency.
ENTER
■ AM frequency step (main unit only)
The step is factory-set to 9 kHz, but you can change it to receive broadcasts
allocated to 10 kHz steps.
1. Select "FM".
2. Press and hold [TUNER, BAND] on the main unit.
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
To return to the original step, repeat the above steps.
Note
Any preset stations are cleared by this procedure. Preset them again.

Preset tuning

2
Select the
frequency of the
MUSIC P.
desired station.
Manual presetting
1
To enter manual
presetting mode.
("PGM" appears)
3
or
Press while the station is flashing
to select the channel.
The station occupying a channel is erased if another station is
preset in that channel.
3
Adjust the
volume.
2
Select the frequency of
the desired station.
23
23