Table of Contents
Advertisement
SC-VK650GCGS.book 24 ページ ２００６年４月１７日 月曜日 午後５時５４分
The radio
Manual Tuning
1
Press [TUNER/MUSIC P.] (main unit: [BAND, TUNER])
to select "FM" or "AM".
The unit comes on.
2
Press [6] or [5] to select the frequency.
Press and hold [6] or [5] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a
station is found.
"TUNED" is displayed when a radio station is tuned.
"ST" is displayed when a stereo FM broadcast is being
received.
∫ If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
Monaural sound is selected and noise is reduced when
reception is weak.
Press [PLAY MODE] again to cancel the mode.
"MONO" is also canceled if the frequency is changed.
∫ AM allocation setting
The step is factory preset to 9 kHz, but you can change it to
receive broadcasts allocated to 10 kHz steps.
1 Select "FM".
2 Press and hold [BAND, TUNER].
After a few seconds the display changes to show the
current minimum frequency. Continue to hold the button
down. The minimum frequency changes and the step is
changed.
To return to the original step, repeat the above steps.
[Note]
After changing the allocation setting, the frequencies you
previously preset in the memory will be cleared. Preset them
again.
24
RQTV0143
24
(Main unit only)
Memory Preset
Remote control only
There are two methods of presetting stations.
Automatic presetting: All the stations the tuner can receive
are preset.
Manual presetting:
You can select the stations to preset
and the order they are preset in.
Up to 15 stations each can be set in the FM and AM bands.
Preparation:
Press [TUNER/MUSIC P.] to select "FM" or "AM".
Automatic presetting
Do the following once each for FM and AM.
Preparation: Tune to the frequency where presetting is to
begin.
Press and hold [ENTER] until the frequency changes.
The tuner presets all the stations it can receive into the
channels in ascending order. The last station to be set is then
played.
Manual presetting
Preset the stations one at a time.
1
Tune to the station (l see left).
2
Press [ENTER].
3
While "PGM" is flashing on the display
Press the numeric buttons to select a channel.
≥To select a 2-digit number
e.g. 12: [S10] l [1] l [2]
The station occupying a channel is erased if another station is
preset in that channel.
Selecting channels
Remote control only
1
Press [TUNER/MUSIC P.] to select "FM" or "AM".
Press the numeric buttons, [:, C/REW] or
2
[9, FF/D] to select the channel.
≥To select a 2-digit number
e.g. 12: [S10] l [1] l [2]
Hide quick links:
Advertisement
Table of Contents
