Setting Up; Connecting The Telephone; Ringer Settings - Geemarc CL1100 User Manual

Now available to purchase from www.M2Cshop.com

SETTING UP

1 - CONNECTING THE TELEPHONE

1 - Connect the handset cord.
2 - Open the battery compartment by pulling back
the latch.
3 - Insert correctly 4 x AAA 1.5V alkaline batteries
(not supplied) in the battery compartment (*). Bat-
teries are required if you wish to increase the
ringer level up to 10 dB.
4 - Snap the battery door back in place.
5 - Connect the line cord to the socket (*).

2 - RINGER SETTINGS

A switch located on the upper side allows the
ringer to be switched HI,LOW,OFF:
: Off,
: Low,
: Hi
(*) Classified TNV-3 according to EN60950 standard.
Now available to purchase from www.M2Cshop.com
6
SETTING UP
Your phone comes with the ringer switched to
«High» and the melody set to «6»:
Low
Melody 1 1
Melody 2 4
Melody 3 7
If you don't like the ringer melody, you can choose
a new one by changing the settings as per
instructions below:
- Lift the handset.
- Press button.
- Press # button.
- Press any of the 1 - 9 dial keys.
The new ringer settings will be activated with the
next incoming call.
Note: The ringer level will be increased up to 10
dB if you insert batteries into the battery
compartment.
Mid High
2 3
5 6
(by default)
8 9
7