Programmed Picture Display (Program) - Silvercrest KH 6778 Operating Instructions Manual

ROOT
Mode
Fig. 2
If there are folders:
ROOT 0
Folder 1 1
Folder 2 2
Mode
Fig. 1
ROOT 0
Folder 1 1
Folder 2 2
Mode
Fig. 2
3 One of the modes is displayed with each depression of
the "OK" button. When the required display mode is dis-
played, then leave the mode select bar by pressing the
control button once. The mark is then once again in
the picture list.
4
If there are no folders:
• Press the "Play" button once to start picture display with
the first picture on the CD-R/CD-RW
• Press the "OK" button once to start picture display at the
currently displayed picture.
If there are folders:
• Press the "Play" button once to start picture display with
the first picture in the current sub-folder
• Press the "OK" button once to start picture display with
the currently selected picture in the current sub-folder.

Programmed picture display (Program)

If you have set "Program Begin" mode to select several pic-
tures for programmed picture display:
48 Silvercrest KH 6778
CD-R MENU
ROOT 0
Picture 1 1
Picture 2 2
Folder Normal
CD-R MENU
.. 0
Picture 1 1
Picture 2 2
Folder Normal
CD-R MENU
.. 0
Picture 1 1
Picture 2 2
Folder Normal
or
or
1
The "Program _:_" field is faded in above the CD-R menu.
Select the first picture that is to be programmed with the
control buttons and
If there are folders: Only one picture at a time from the
current sub-folder can be selected for programmed pic-
ture display. Pictures from different sub-folders cannot
be selected for programmed picture display.
2 Confirm selection by pressing the "OK" button on the
remote control once.
3
The selected picture is then displayed in the faded-in
field above the CD-R menu as the first stored picture for
programmed picture display, e.g. "Program 1:05" if the
fifth picture of the current sub-folder has been selected
as the first picture for programmed picture display.
4 Repeat steps 1 and 2 until you have selected all required
pictures for programmed picture display.
5
Press the control button
select bar.
6 Press the "OK" button once; the "Program End" mode is
then displayed in the mode select bar.
7
Press the Control button
menu.
8 Press the "Play" button on the front of the DVD Player or
on the remote control once to start programmed picture
display.
9
Press the "Skip" or "Skip"
the DVD Player within the programmed pictures to jump
forward to the next picture or back to the previous pic-
ture.
10
To cancel programmed picture, press during display the
"Stop" button on the front of the DVD Player or on the
remote control twice.
on the remote control.
once to change the mode
once to return to the CD-R
buttons on the front of