Setting The Television Standard; Setting Video Output - Silvercrest KH 6778 Operating Instructions Manual

Please note:
The correct setting depends on the television with
which the DVD Player is to be connected. If you are not
sure which screen format your television can present,
then please refer to the operating instructions for the
given television.

Setting the television standard

6 Press the control button
item "TV System".
7
Press the "OK" button once. The available operations for
the sub-item "TV System" will then be displayed:
Auto
The standard in which the DVD/VCD/S-VCD was recorded
is automatically selected in this setting. Only set "Auto"
if the DVD Player is connected to a multi-standard
television!
PAL
DVDs/VCDs/S-VCDs recorded in the PAL standard are
played in this setting. DVDs/VCDs/S-VCDs recorded in
NTSC standard are automatically converted so that they
can be played in the PAL format. Set "PAL" if the DVD Player
is connected to a PAL television.
NTSC
DVDs/VCDs/S-VCDs recorded in the NTSC standard are
played in this setting. DVDs/VCDs/S-VCDs recorded in the
PAL standard are automatically converted so that they
can be played in the NTSC format. Set "NTSC" if the DVD
Player is connected to an NTSC television.
8 Select the appropriate television standard with the con-
trol buttons and confirm by pressing the "OK" button
once.
Please note:
The correct setting depends upon the television with
which the DVD Player is to be connected. Most tel-
evisions will conform with the television standard in
your country except if the television was purchased
abroad.
If you are not sure which is the customary television
standard in your country, then refer to the operating
instructions for the given television, or turn to the
Glossary in the instructions to find the explanation
under the headword "Television Standard".
➧ For this subject please refer to Chapter 17. "Glossary/In-
dex".
once to select the menu sub-

Setting Video Output

9
Press the control button
item "Video Output"
10 Conform by pressing the "OK" button once. The available
options for the sub-item "Video Output" will now be dis-
played:
RGB
Setting to connect the DVD Player to an RGB-capable
television with a 21-pin SCART cable
S-Video
Setting to connect the DVD-Player via S-Video
YUV
Setting to connect the DVD-Player via component
signal
YPbPr
Setting to connect the DVD-Player via component signal
YPbPr (Progressive Scan)
Warning!
In the event that the wrong video output is set – e.g.
"YPbPr" although the television is not Scan-capa-
ble – then the television screen may suddenly turn
black.
This is not a defect of the television or DVD Player!
In such an event ...
• Press once the "Stop" button on the front panel
of the DVD Player or on the remote control and
• then continue pressing the "Video Out" button on
the remote control until the picture reappears on
the television screen.
11 Then select with the control buttons
for the video output that matches the connection of the
DVD Player with the television.
12 Confirm the selection by pressing the "OK" button once,
thereby concluding the video setting procedure.
13
Press the control button
OSD menu bar.
once to select the menu sub-
and the setting
three times to return to the
Silvercrest KH 6778 15