Dell Force10 MXL Deployment Manual page 44

Deploying FCoE (FIP Snooping) on Dell Force 10 MXL
Step by step explanation of Dell Force10 MXL CLI example with multiple port (LAG) uplink (this only
covers the differences from the
interface TenGigabitEthernet 0/1 – configure internal interfaces that connect to the blade
o
servers.
 portmode hybrid – configuring portmode hybrid will allow for the native VLAN untagged,
and a tagged VLAN to exist on the port together. This is similar to switchport mode trunk in
industry standard CLI.
switchport – this configures the port as a layer 2 port.

 protocol lldp – this moves into the lldp protocol settings.
dcbx port-role auto-downstream – with this command the port-role is established

as a dcbx capable downstream port to communicate with blade server CNA ports.
spanning-tree pvst edge-port – configure port as an edge port for spanning-tree behavior

no shutdown – configures the port as active.

 exit – exits interface configuration mode
interface TenGigabitEthernet 0/2 – configure internal interfaces that connect to the blade
o
servers.
portmode hybrid – configuring portmode hybrid will allow for the native VLAN untagged,

and a tagged VLAN to exist on the port together. This is similar to switchport mode trunk in
industry standard CLI.
switchport – this configures the port as a layer 2 port.

protocol lldp – this moves into the lldp protocol settings.

 dcbx port-role auto-downstream – with this command the port-role is established
as a dcbx capable dowsnstream port to communicate with blade server CNA ports.
 spanning-tree pvst edge-port – configure port as an edge port for spanning-tree behavior
no shutdown – configures the port as active.

 exit – exits interface configuration mode
interface TenGigabitEthernet 0/51
o
 port-channel-protocol LACP – configures the port for LACP port-channel
port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active

 protocol lldp – this moves into the lldp protocol settings.
no advertise dcbx-tlv ets-reco – this settings establishes that the ETS recommended
o
configuration TLV's should not be advertised for manual type settings. Instead they
should be determined via negotiations
dcbx port-role auto-upstream – with this command the port-role is established as a
o
dcbx capable upstream port to communicate with top-of-rack FCF switches such as the
Cisco Nexus 5000 series.
no shutdown – configures the port as active.

 exit – exit from interface configuration mode
interface TenGigabitEthernet 0/52
o
port-channel-protocol LACP – configures the port for LACP port-channel

·
port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active
protocol lldp – this moves into the lldp protocol settings.

no advertise dcbx-tlv ets-reco – this settings establishes that the ETS recommended
o
configuration TLV's should not be advertised for manual type settings. Instead they
should be determined via negotiations
single port configuration).
44