Installation Requirements; Electrical Requirements; Tools And Parts - KitchenAid KECD867XBL01 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
• Tape measure
• Flat-blade screwdriver
• Phillips head screwdriver
• Drill
• Level
• Marker or pencil
• Pliers
• 1¼.drill bit
• Jigsaw
• Ratchet with 3/8"socket
• Grounded electrical supply is required. See "Electrical
Requirements" section.
• If cabinet has drawers, drawers will need to be removed and
drawer fronts installed on front of cabinet.
IMPORTANT: An under-counter built-in oven cannot be installed
under this product.
Product Dimensions
30" (76.2 cm) Cooktop - for standard and electric models
• 6" socket extension
Parts supplied
• Vent grille
• Pre-filter
Parts needed
• A UL listed or CSA approved strain relief for 7/8" (2.2 cm)
knockout.
• A UL listed or CSA approved conduit connector for
1/2"(1.3 cm) trade-size metal-clad conduit
• UL listed wire connectors
Metal ducting
Wall cap
6" (15.2 cm) Round Surface Wall Cap Damper
Order Part Number A406
5" (12.7 cm) Round Surface Wall Cap Damper
Order Part Number A405
31¼"x 10" (8.3 x 25.4 cm) Surface Wall Cap Damper
Order Part Number A403
To order, see the "Assistance or Service" section of the Use
and Care Guide.
• Vent clamps
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section.
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
IMPORTANT: Observe all governing codes and ordinances.
When installing cooktop, use minimum dimensions given.
• To eliminate the risk of burns or fire by reaching over the
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to
be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
• Use the countertop opening dimensions that are given with
these Installation Instructions. Given dimensions are
minimum clearances and provide 0" (0 cm) clearance.
A. Model/serial rating/clearance plate location
B. 21" (53.4 cm) screw head to screw head
C. 22" (52.3 cm) without stainless steel trim or
21 s7/64 ' ' (54.8 cm) with stainless steel trim
E
i C--------_
@ ® ©
J
F_ i_ i_-.------------J- H
i_--G i
A. 30½_" (76.3 cm) with stainless steel trim
B. 291%6 '' (76.1 cm) without stainless steel trim
C. 14%d' (36.4 cm)
D. 331/32 ''
(10.1 cm)
E. 1813/32 '' (46.8 cm)
F. 1_½_ '' (3.4 cm)
G. 13s/3_ '' (33.3 cm)
H. 14s/le '' (36.0 cm)
I. 28%" (72.7 cm) screw head to screw head