Step 5 Connect Power; Step 6, Slide Product Into Cutout; Step 7 Set Temperature Controls - GE ZIFI240 Installation Instructions Manual

STEP 5 CONNECT POWER

• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
• Bar Refrigerator with Icemaker – The interior fan runs
all the time except during defrost cycle when the door
is open.
• Fresh-Food Refrigerator – The interior fan runs
all the time except when the door is open.
See the Owner's Manual for further explanation of the fan.
STEP 6 SLIDE PRODUCT INTO
THE CUTOUT
CAUTION:
Do not push against the door
panel with your knees. Do not push or lift the unit by
the door handle. Damage may occur!
ATTENTION :
le panneau de la porte avec vos genoux. Ne poussez
jamais votre appareil ou ne le soulevez jamais par
la poignée de porte. Vous pouvez l'endommager.
• Open the door and gently push the unit back into
the opening with your hands against the sides.
Be careful not to entangle power cord.
• In a standard 24" opening, the front face of
the stainless steel door will be flush with adjacent
cabinetry. A custom panel door may protrude
1-3/4" beyond the surrounding cabinets.
• Check again to be sure the unit is level.
• If the unit is installed under a countertop, adjust
the leveling legs until the unit is resting firmly against
the underside of the countertop.
• If alignment with adjacent cabinetry is an issue,
use a shim to secure the unit against the underside
of the countertop.
Installation Instructions
Ne poussez jamais
STEP 7 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to
the Owner's Manual for more information. Allow
12–24 hours for the temperature to stabilize.
NOTE: The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker operate very quietly. You may not notice the unit
running, and when first installed, the fans and motor may
not come on immediately – this is normal. If the display is
lit and the light is working, the unit is operating.
8