Setting Reception Restriction; Unknown Number Reception - Kyocera FS-C2126MFP Operation Manual

Setting Reception Restriction

You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No.
and Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject
List] for Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from
senders whose Local FAX Number is not registered are rejected. To change the reception restriction, follow the
steps below.
TX/RX Restrict.: a b
1
TX Restriction
2 RX Restriction
*********************
3
Permit No. List

Unknown Number Reception

Select whether to receive the fax of that the number is unknown when [Reject List] is set for Reception
Restriction. To change the reception restriction for the unknown fax number, follow the steps below.
TX/RX Restrict.: a b
4 Permit ID List
5
Reject No. List
6
********************* UnknownNumber RX
1
Refer to Basic Operation Procedure on page 6-7.
2
Press the
[ Exit ]
3
Press the OK key.
4
Press the
restriction. To not use the reception restriction,
select [Off]. To restrict the other parties only to the
ones registered in Permit FAX No. and Permit ID
No. as well as the ones registered in the Address
Book, select [Permit+Addr Book]. To block
incoming faxes from senders registered in Reject
FAX No., select [Reject List].
5
Press the OK key.
1
Refer to Basic Operation Procedure on page 6-7.
2
Press the
RX].
[ Exit ]
3
Press the OK key.
6-37
Setup and Registration
or key to select [RX Restriction].
or key to select reception
or key to select [UnknownNumber
6