Setting Up The Power Supply; Turning The Power On - Yamaha DTXTREME III Owner's Manual

Setting Up

Setting Up the Power Supply

1
Make sure that the STANDBY/ON switch of
the instrument is set to STANDBY (
2
Connect the DC plug of the included AC
power adaptor to the DC IN jack on the
rear panel. To prevent the cord from being
unplugged accidentally, wrap the cord
around the cable clip and secure it.
CAUTION
• Make sure that the power adaptor's cord is not bent at an extreme
angle when wrapping the cord around the clip. Doing this can dam-
age or sever the cord and create a fire hazard.
3
Connect the other end of the power cord
to an AC outlet.
WARNING
• Use only the included power adaptor or an equivalent recom-
mended by Yamaha. The use of any other adaptors may cause
irregular operation or damage to the device.
• Only use the voltage specified as correct for the DTXTREME III.
• Even when the instrument is turned off, electricity is still flowing to
the instrument at the minimum level. When you are not using the
DTXTREME III for a long time, make sure to unplug the AC power
adaptor from the wall AC outlet.
18
DTXTREME III Owner's Manual

Turning the Power On

After you've made all necessary connections (trigger,
). audio, MIDI), turn down all volume controls of the DTX-
TREME III and other audio equipment.
Turn the power on (
switch on the rear panel of the DTXTREME III, then turn
on the power of the amplifiers.
■
Connecting a mixer or other MIDI
devices
Make sure that all volume settings are turned down all the
way to the minimum. Then turn on the every device in your
setup in the order of MIDI masters (controllers), MIDI
slaves (receivers), then audio equipment (mixers, amplifi-
ers, speakers, etc.).
1 DTXTREME III
(transmitting device)
888
3
External audio equipment
(mixer → amplifier)
NOTE
• When powering down the setup, first turn down the volume for each audio
devices, then switch off each device in the reverse order (first audio equip-
ment, then MIDI).
) by pressing the [STANDBY/ON]
2
MIDI slave