4. Addstrain relief.
• Replace cord/conduit plate and insert s crews.
Style 1: Power supply cord strain relief
•
Assemble a UL listed strain relief in the opening.
I;
-
J
-
"
(
......
.......
i ....... /"
"_
"_\
...........
A
'\
/
_,,'
', i................
"-_',, .:_ ,,):_7_::zzzz:
.........
-,,
A. UL listed strain relief
Feed the power supply cord through the strain relief in the
cord/conduit
plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
•
Tighten strain relief screw against the power supply cord.
•
Assemble a UL listed conduit connector
in the opening.
Style 2" Direct wire strain relief
•
Use Phillips screwdriver to remove screws and slide
cord/conduit
plate down and out.
5.
A. Removable retaining nut
B. Strain relief
•
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
•
Tighten strain relief screw against the flexible conduit.
Replace back panel and screws on rear of range.
Position cord/conduit
plate as shown in the following
illustration.
10