KitchenAid KDRS505XSS00 Installation Instructions Manual page 12

Style 2: Direct wire strain relief
• Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
• Position cord/conduit plate as shown in the following
illustration.
• Replace cord/conduit plate and insert screws.
r ...............
• Assemble a UL listed conduit connector in the opening.
ii _Ji
; ")_t.::::::: ........................................ A
............... t
A. Removable retaining nut
B. Strain relief
• Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
• Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be Go to Section:
connecting to:
4-wire receptacle A UL listed,
(NEMA type 14-50R) 250-volt
minimum,
40-amp, range
power supply
cord
4-wire connection:
Power supply cord
4-wire direct A fused
disconnect or
circuit breaker
box
(12.7 crn)
4-wire connection:
Direct wire
3-wire receptacle A UL listed,
(NEMA type 10-50R) 250-volt
minimum,
(_ 40-amp, range
power supply
cord
3-wire connection:
Power supply cord
3-wire direct A fused
1- disconnect or
(2.5cm)_ circuit breaker
box
3-wire connection:
Direct wire
12