Finisher - Konica Minolta KM-7145 Instruction Manual

4.
Position original(s).
Using platen glass:
Place original FACE DOWN. Start scanning from the first page.
When Dual Page, Non-Image Area Erase, Auto detection mode of Repeat,
or AUTO Layout is selected, keep the RADF open throughout the scanning
procedure.
Using RADF:
Position originals FACE UP.
If the number of originals exceeds 50, divide them into blocks not exceeding 50 sheets
and load them from the block with the first page.
See p. 3-2 to p. 3-6 for details on positioning originals.
5.
Press [START] to scan.
Repeat steps 4 and 5 until all originals are scanned.
Memory indicator on the upper right of the Basic Screen allows you to check
the remaining memory.
To delete the scanned data without printing, press [STOP].
Should memory overflow occur frequently, it is recommended that you
contact your service representative to expand the memory capacity in your
machine.
6.
Touch STORE to exit the Store mode.
STORE will return to the normal display.
7.
Press [START] to print.
All the data in memory will be output.
Press [STOP] to suspend the printing job.
When the finisher / paper exit / inner tray capacity is exceeded due
to the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
Copying Using Memory (continued)
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without

Finisher

Output with
Finisher
Staple
Punch
Fold /
Fold&Stitch
Output with
Inner Tray
3-27