Outside Air Boot Installation - Lopi Liberty Owner's Manual

Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".
1 The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the thermodisk.
Use the wire clip to insure the wires from the thermodisk are held in place away from the firebox (this
prevents damage to the wires).
Thermodisk
Wire Clip
The wires pass through the eye of the wire clip.
Blower Box
FRONT
© Travis Industries
Optional Equipment
This portion
hooks on the
top edge of the
rear heat shield.
This portion of the wire
clips slides over the
rear heat shield
The two yellow wires
attach to the thermodisk.
100-01161
Three holes for
attaching the
blower box to the
back of the stove
Slide the
thermodisk
assembly into
the space
between the
stove and rear
heat shield.
Run both of the
wires from the
thermodisk down
behind the stove
and through the
eye of the wire clip.
Wire Clip
Power Cord
(exits from back
of blower box)
4110912
37