American DJ Accu Spot 250 Hybrid User Instructions page 14

Accu Spot 250 Hybrid
DLAY
- With this function you can set a lamp delay time.
1. Access the main menu by pressing MODE/ESC button.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DLAY" is displayed, press ENTER.
4. The display should show "D-00". Press the UP button in
order to select your desired delay time.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
SPOT
- With this function you can adjust the lamp via
the control board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any con-
trol signal.
1. Access the main menu by pressing MODE/ESC button.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "SPOT" is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either "ON" to acti-
vate this function, or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
DFSE
- With this function you can restore the factory set-
tings of the device. All settings will be set back to default
settings. Any saved or edited scenes will be lost. When
restoring the factory settings the unit must be set to the
address that the unit was in when you started editing.
1. Access the main menu by pressing MODE/ESC button.
American DJ - www.americandj.com - Accu Spot 250 Hybrid Instruction Manual Page 27
®
System Menu Accu Spot 250 Hybrid
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "DFSE" is displayed, press ENTER.
4. The display will show "ON/OFF".
5. Press the UP button to display "ON" to activate this function,
or "OFF" to deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
When you exit this function, the unit will begin to reload
data.
FEED
correction on and off. This will automatically correct the
Pan/Tilt if it is somehow moved out of place.
1. Access the main menu by pressing MODE/ESC button.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "FEED" is displayed, press ENTER.
4. Press the UP or DOWN buttons to select either "ON" to acti-
vate this function, or "OFF" to deactivate this function.
5. Press ENTER to confirm.
6. Press MODE/ESC to return to the main menu.
VER
the unit.
1. Access the main menu.
2. Tap the UP button until "SPEC" is displayed, press ENTER.
3. Tap the UP button until "VER" is displayed, press ENTER.
American DJ
- With this function you can switch the Pan/Tilt error
- Use this function to display the Software version of
- www.americandj.com - Accu Spot 250 Hybrid Instruction Manual Page 28
®
System Menu