American DJ SWEEPER BEAM LED User Instructions

User Instructions
3/13
Sweeper Beam LED
Unpacking:
Thank you for purchasing the Sweeper Beam LED by
ADJ Products, LLC. Every Sweeper Beam LED has been thoroughly
tested and has been shipped in perfect operating condition. Carefully
check the shipping carton for damage that may have occurred during
shipping. If the carton appears to be damaged, carefully inspect your
fixture for any damage and be sure all equipment necessary to oper-
ate the unit has arrived intact. In the event damage has been found
or parts are missing, please contact our toll free customer support
number for further instructions. Please do not return this unit to your
dealer without contacting customer support first.
Introduction:
The Sweeper Beam LED is an intelligent, 8-zone LED,
beam effect. The Sweeper Beam LED can operate as a stand alone
fixture or in a Master/Slave configuration. The Sweeper Beam LED has
three operating modes; sound active mode, show mode, and DMX
control. This fixture is suitable for theaters, studios, retail stores, and
other similar locations. This fixture is suitable for theaters, studios,
retail stores, and other similar locations. For best results use fog or
special effects smoke to enhance the beams projections.
Customer Support:
ADJ Products, LLC provides a toll free cus-
tomer support line, to provide help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.adj.com for any comments or
suggestions. Service Hours are Monday through Friday 8:00 a.m. to
4:30 p.m. Pacific Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2941
E-mail: support@americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Warning!
This may cause severe eye damage. Avoid looking directly
into the light source at all times!
ADJ Products, LLC - www.adj.com - Sweeper Beam LED User Manual Page 2
General Information