Table of Contents
Advertisement
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
Phenomenan
The digitron displays E0.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2.
The safety switch acts, and the
spinning cannot work. The
digitron displays E3.
The water filling does not work, or is
slow. After about 30 minutes later,
the digital displays E4.
The digitron displays E6.
The digitron displays EE.
Not wash
The machine does
not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
* The spinning is intermittent when it starts
* The wash procedure pauses.
* Select
Spin
program, but it doesn t work.
* The pulsator pauses during washing, rinsing or adding water.
* There may be some water flowing out of the drain hose in the first
use of the machine.
* When selecting " No washing powder " or " Disinfect " function,
there is a small quantity of water flowing out of the drainpipe
during water filling.
The reason
The top lid is opened during reserve
procedure.
Is the drain hose put down?
Is the drain hose blocked?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
* Balance the laundries to avoid slanting.
* The cloth sensor is detecting the cloth. It will start adding water
after about 48 seconds.
* The program is setting the drain time. A certain period is needed
before it starts spinning.
* It is to avoid splashing during water filling.
* It is the water remained in the performance inspection by the factory.
* When selecting " No washing powder " function, what is expelled
from the drainpipe is disinfector during water filling , which can
sterilized the gully and wiping rags, etc.
* When selecting " Disinfect " function, what is expelled from the
drainpipe is decontaminating water during water filling , which
clean the gully and wiping rags, etc.
16
How to settle
Close the top lid.
Put down the drain hose. Open and close the
top lid once.
Clean the foreign material. Open and close
The top Lid Once.
Close the top lid.
Reorder the laundries. Close the top lid.
Place the machine horizontally. Open
and close the top lid once.
Open the water tap. Push the start/pause
button once.
Clean the water inlet valve then push
the start/pause button once.
Open and close the top lid once. .
Please contact the after-sales
service department.
Open the water tap. Push the start/pause
button once.
Clean the water inlet valve then push
the start/pause button once.
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
Explanation
Advertisement
Table of Contents
