Advertisement
Installation
As shown in Fig.1, remove all the packing materials
( in cluding the foam base ). It is normal that there are
some water drops on the plastic bag, the cushion and
the porthole. It is because of the water testing before
leaving the factory.
Check attachments and materials
Operational
Quality
Name
manual
certificate
Quantity
1
1
Remove the packing screws as shown in Fig.2.
The packing bolts protect the appliance from impact damage during
transportation. Follow the steps below before using the appliance.
1. Remove the rear panel of the washing machine;
2. Remove the three packing bolts from the rear panel of the washing
machine, the rubber hose and then the shock ablorption steel channel;
3. Refit the back plate;
4. Fill the holes left by the packing bolts with plastic plugs.
( Attention: the packing bolts and rubber hose should be kept in a
safe place for later use )
There is a plastic jacket packing the door catch, please remove it
when you unpack the machine. Do not let children touch it to void
dangerous things.
Adjusting the position of the washing machine.
The washing machine is provide with adjustable feet. Before use,
adjust the feet until the appliance is level, as shown in Fig.3.
4
Fig.1
Water
Drain
Plastic
hose
holder
plugs
1
1
3
Fig.2
Fig.3
Maintenance
1. Remove the power plug, open the porthole
and turn off the tap after washing to avoid to
produce damp and strange smell in the drum.
If the washing machine is not going to be used
for a long period of time, put the drainage hose
as lower as possible to let the water in the pipe
out for avoiding the water turns bad quality and
then put the pipe to the original place.
3. Clean the detergent
cartridge regularly:
Pull the detergent cartridge
up and out then wash it out.
Put it back when it is clean.
5. Clean the filter ( once a month )
Press the lower edge of the filter compartment
cover to open; ( Fig.1-2 )
Remove the filter by turning counterclockwise;
( Fig.3 )
Flash clean with running water;
Filter replacement is the reverse of removal.
Caution: Attention shall be paid to ensure that
the filter is replaced correctly to avoid possible
leakage.
Using a flat-nose screw driver prizes the slits
of two ends of the button panel and move the
panel out with your hands. ( Fig.4-5 )
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
7. Remove the power plug and turn off the tap and open the door if the machine is not going
to be used for a long period of time. With the method there would not be any bad smell inside
the tube.
2. The dissolved agent and anti-
septics should not be used to
clean the surface of the ma-
chine and rube apares. Only
the clothing soaked with some
soap liquid is suggested.
Warning: Remove the power
socket before the cleaning.
4. To prevent blockages to the
water supply or the ingress of
contaminants, clean the water
inlet and inlet water filter
regularly.
6. If the machine is to be moved a distance
location, replace the vibration mounting locks
which were removed during installation as
shown below.
Remove the
Replace the
back cover
rubber plugs
Insert the channel
Tighten the bolts
steel vibration locks
with a spanner
insert the bolts
Replace the back cover
13
Advertisement
