JVC CA-NXG7 Instructions Manual page 4

Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your
complete understanding and to obtain the best possible performance from the System.
Precautions
Installation
• Install the System in a location with adequate
ventilation to prevent internal heat build-up in the
System.
DO NOT install the System in a
location near heat sources, or in a place
subject to direct sunlight, excessive dust
or vibration.
• Install in a place which is level, dry and neither too
hot nor too cold—between 5°C and 35°C.
• Leave sufficient distance between the System and the
TV.
• Keep the speakers away from the TV to avoid
interference with the TV.
Power sources
• When unplugging the System from the wall outlet,
always pull on the plug, not the power cord.
DO NOT handle the power cord with
wet hands.
Moisture condensation
Moisture may condense on the lens inside the System
in the following cases:
• After starting to heat the room
• In a damp room
• If the System is brought directly from a cold to a
warm place.
Should this occur, the System may malfunction. In this
case, leave the System turned on for a few hours until
the moisture evaporates, unplug the power cord, then
plug it in again.
Internal heat
• Make sure there is good ventilation around the
System. Poor ventilation could overheat and damage
the System.
DO NOT block the ventilation
openings or holes. If they are blocked
by a newspaper or cloth, etc., the heat
may not be able to get out.
1
text_EN_NXG7G3.indb 1 text_EN_NXG7G3.indb 1
Introduction
Others
Should any metallic object or liquid fall into the
System, unplug the power cord and consult your dealer
before operating any further.
DO NOT disassemble the System since
there are no user serviceable parts
inside.
• If you are not going to operate the System for an
extended period of time, unplug the power cord
from the wall outlet.
If anything goes wrong, unplug the power cord and
consult your dealer.
How to Read This Manual
• Button and control operations are explained in the
table below.
• Some related tips and notes are explained later in
the sections "Learning More about This System"
and "Troubleshooting," but not in the same
section explaining the operations (
that the content has some information).
• Illustrations used in this manual is mainly of CA-
NXG7. They may look different from the model you
have.
2
sec.
indicates
Indicates that you press the button
briefly.
Indicates that you press the button
briefly and repeatedly until the
option you want is selected.
Indicates that you press one of the
buttons.
Indicates that you press and hold the
button for a specified period.
Indicates that you turn the control in
the specified direction(s).
Indicates that this operation is only
possible using the remote control.
Indicates that this operation is only
possible using the main unit.
08.6.25 2:21:45 PM 08.6.25 2:21:45 PM