Advertisement
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the bottom plate
After you open the package, please
lean the washing machine gently down
on soft items ( like the towel cloth,
blanket, etc. ). Install the bottom plate
to the bottom of the machine with
the eight screws by a cross screwdriver,
then lift the machine up gently. See to the
figure:
Adjust the Installation position
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground
will result in unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Back
Front
Bottom plate
Soft items
Screw
the adjustable nut
Fasten
Loosen
the adjustable feet
High
Low
4 Push the " water level" button, select suitable water level
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth.
After defection, it can set the water level automatically. To select other water level, first push the "start/pause"
button, then push the "water level" button to set the water level.
5 Push the "reserve" button to select suitable reserve
wash program
After switching on the power, the reserve program is set to off mode automatically. If you need to
set the washing procedure to be finished at reserved time, please push the " reserve " button to
set the reserve wash program. Refer to reserve button in Page 10 for selection.
Confirm the operation of reserve program
When the "reserve" function is activated, the indicator light of the program you
have set will be off. The "reserve (hour)" and "time remain" indicator lights will
be on. During reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
6 Push the "Air dry"button
Attention:after switiching on the power,the function of the "dry" and "program" is
not selected at same time
7 Push the "Start/Pause" button
6 Finish washing
After finishing wash
it'll alarm automatically
Advertisement
