Table of Contents
Advertisement
INTEGRATED
DRAWER FRONT INSTALLATION
There are several different colored Integrated badges to choose from. They
include black, chrome, satin & brass. Two color options are provided with
your rnachine, other optionsare available from your local Dealer.
There are five parts 1othe
Integrated Badge Assembly.
They are as follows:
1.
Inlegrated Badge
2.
Button Badge
3.
Light Pipe
4.
Electronics Board
5.
Badge Cover
t t
•
e
o
o
Remove Badge Cover from the Integrated Badge.
At the back of the Integrated Badge, slide the Badge Cover away from the
wire terminals.
Remove Electronics Board.
Gently hold the wires to remove the Electronics Board. Care should be
taken not to handle the front or back of _e Electronics Board or touch
inside the wire terminals.
Remove the Light Pipe.
Gently tap the Integrated Badge upside down on a hard surface until the
Light Pipe comes away or insert a pen or pencil into the front side of the
Integrated Badge to either one of the two small holes.
J
Once you have removed the Electronics Board, Badge Cover and tight
Pipe, you can change the color of the Integrated Badge.
I
•
2.
3.
J
Insert the Button Badge into the back of the Integrated'Badge. Do not
break any of the buttons away from the Connection Runner.
Insert the Light Pipe into the Integrated Badge.
Insert the Eight Pipe with the circular ends into the small holes.
h_serl the Eh!(t_onics
Board with care, behind the Button Badge.
When
installing
the Electronics
Board, handle only the wires and do not
touch lhe lace or back of the Electronics
Board or inside the wire
terminals.
4.
Slide the Badge Cover into the slot on top of the Integrated
Badge.
Button Badge"
"1'
Connection
l_Ui_ll_,;
Page DS_ 18
Advertisement
Table of Contents
