Table of Contents
Advertisement
FINAL CHECKS
Ensureproduct is level, securely fastened to lhe floor and opens
and closesfreely.
Ensure inlel hose to faucet (-onneclion is tightened
to specification.
Insure any knockouts or plugs in drain connection have lxeen
dr ed out and dra n connection made to specification.
Plug in and turn ON the power and water supply. The DishDrawer
should "beep" and light up.
Open the drawers of the DishDrawer
and check operation
of
Secondary Control
Panel and check sprayarm(s) are in place and
free to rotate.
b.
Select Rinse program on the Secondary
Control Panel and close the
drawers.
7.
Staff the Program by pressing the Start/Pause button.
8.
After tile program has finished, check underneath the DishDrawer
for water leakage. Ensure machine has,jun and drained correctly.
9.
Check water supply and drainage connection for leakage.
10.
Repeat for each Drawer.
[]
[]
5
[]
[]
[]
[]
[]
[]
[]
l,'JllNlli [ l![ml
|_o_!
_oze_
•
2.
3.
4.
5.
Water underneath
DishDrawer,
check the hose connections
and
hose for leaks_
Water around water supply and drainage
connections
- check
connections,
existing
plumbing
and hoses for leaks.
Excessive water remaining above the filter plate, after the rinse
cycle, check for kinked drain hosesor blocked was_ connection.
No water supply, check water is on and there is water pressure.
If a faull occurs, consult the Problem Solver Section of the Use &
Care Manual.
]
.
.O
[]
[]
[]
6.
If unable Io resolve, conlacl Cuslomer
Care C'enler.
[]
Ensure Power is connected
and is switched
ON.
Ensure the water supply is connected
and ON.
[]
[]
LEAVE ALL LITERATURE WITH
THE CUSTOMER.
Page DS_22
Advertisement
Table of Contents
