Table of Contents
Advertisement
_ INSTALLATIONINSTRUCTIONS
STEP 5: ELECTRICAL
CONNECTION
7
POWER
OUTLET
This view shows the bottom left-hand rear corner with the cover removed
DishDrawer ®
_WARNING!
The product MUST NOT be
plugged in at this stage,
_WARNING!
If permanently connecting be
sure the power is isolated.
li_Be
sure there is a power outlet in reach of the supplied power cord.
If there is not a suitable outlet available then have one installed by a
qualified electrician,
Do not use an extension cord,
li_
Alternatively, the DishDrawer®
be
connected to a
permanently
may
flexible conduit,
Remove the power supply cord.
Remove round knock-out for cable
clamp, Fit suitable cable clamp for the conduit and terminate the
wiring as shown. Terminate the ground wire using the saddle that
was used on the existing earth,
/_WARNING!
This must only be done by a certified person.
STEP 6:
REFITtiNG THETUB
Important!
Before refitting the tub, be sure the hoses are not twisted
and the
latches at the rear of each drawer runner are facing forward.
li_To
refit the
make
both of the latches
the
of each
tub,
sure
at
rear
drawer runner are facing forward,
Ensure hoses are hooping
upward,
Place the tub on the half open drawer runners and close
the drawer.
i]_
Check the tub clips have reset on both sides of the tub. If not, pull
the tub clips forward until the tub clip button is reset.
Important!
Be sure the tub clips on both sides are reset.
Hide quick links:
Advertisement
Table of Contents
