Electrical Connection; Refitting The Tub - Fisher & Paykel V3 DD603 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
STEP 5:

ELECTRICAL CONNECTION

14
This view shows the bottom left-hand rear corner with the cover removed
15
STEP 6:

REFITTING THE TUB

16
17
WARNING!
The product MUST NOT be
plugged in at this stage.
14
Be sure there is a power outlet in reach of the supplied power cord.
If there is not a suitable outlet available then have one installed by a
qualified electrician.
Do not use an extension cord.
15
Alternatively, the DishDrawer® may be permanently connected to a
flexible conduit.
Remove the power supply cord. Remove round knock-out for cable
clamp. Fit suitable cable clamp for the conduit and terminate the
wiring as shown. Terminate the ground wire using the saddle that
was used on the existing earth.
WARNING!
This must only be done by a certified person.
Important!
Before refitting the tub, be sure the hoses are not twisted and the
latches at the rear of each drawer runner are facing forward.
16
To refit the tub, make sure both of the latches at the rear of each
drawer runner are facing forward. Ensure hoses are hooping
upward. Place the tub on the half open drawer runners and close
the drawer.
17
Check the tub clips have reset on both sides of the tub. If not, pull
the tub clips forward until the tub clip button is reset.
Important!
Be sure the tub clips on both sides are reset.
WARNING!
If permanently connecting be
sure the power is isolated.
9
R