Edit Tone Parts; Edit System; Sync - Roland BK-7m Owner's Manual

Backing Module BK-7m
Menu options
Filter Setting
Soft Off, On
Caf Off, On
RPN Off, On
NRPN Off, On
System Off, On
Exclusive
CC16 Off, On
Select All Off, On
Tx, Tx Ch, Tx Shift, Tx Local, Tx Event
For the explanation of these parameters please refer
to "Rx Event" on p. 67.

Edit Tone Parts

The following parameters are located on the display
page that can be selected using [MENU] button‰
"MIDI" ‰ "Edit Tone Parts".
NOTE
We recommend using the wizard to quickly set up the
BK-7m for new MIDI controllers you may want to use. See
"Wizard Connection" on p. 22. Only then should you
change the settings that are not suitable for your applica-
tion.
1.
Use the [CURSOR÷VALUE] dial to select the
part you want to edit (MBS, LWR, UP2, UP1).
The display now shows the settings for the selected
part.
Rx, Rx Ch, Rx Shift, Rx Event
For the explanation of these parameters please refer
to "Edit Song Parts" on p. 67.
68
Explanation
Select "On" to filter Soft
messages (CC67).
Select "On" to filter Caf-
Channel aftertouch.
Select "On" to filter Regis-
tered parameter number
messages (CC100/101).
Select "On" to filter Non-
registered parameter num-
ber messages (CC98/99).
Select "On" to filter System
Exclusive messages.
General purpose controller
that allows you to influence
the "C1" parameter (see
p. 54).
Select "On" to filter all MIDI
message listed above.

Edit System

The following parameters are located on the display
page that can be selected using [MENU] button‰
"MIDI" ‰ "Edit System".
The "Edit System" group contains the following
parameters:
Edit System Explanation

Sync

These parameters are used to synchronize
external MIDI devices. See below.
Basic The parameters of this group affect the
BK-7m's Basic channel. The Basic channel
is used to receive and transmit Program
Change and Bank Select messages for
selecting Performances as well as for the
reception and transmission of other kinds
of messages that are not directly related
to a specific MIDI channel. See page 69.
Style The parameters of this group affect the
BK-7m's Style channel. The Style channel
is used for receiving program change and
bank select messages that select Styles
and volume messages that change the
Style's volume. See page 70.
NTA These parameters allow you to assign MIDI
channels to the BK-7m's NTA parts (Note-
to-Arranger). Only notes received on one
of these channels are considered chord
information that can be used to transpose
Music Style playback in real-time. See
page 70.
Parameters This group contains MIDI parameters that
are not related to the previous groups. See
page 71.
Sync
The following parameters are located on the display
page that can be selected using [MENU] button‰
"MIDI" ‰ "Edit System" ‰ "Sync".