Roland BK-7m Owner's Manual page 64

Backing Module BK-7m
Menu options
The following table shows the utility parameters.
Parameter Setting
Song Quick Off, 2nd bar,
Start 1st note
Perform Next Off, On
Song
REC Audio –24, –18, –12,
Level –6, +0 dB
REC Audio Sync Off, On
64
Explanation
Off: Playback starts at
the very beginning of
the song file (which
may contain a few
silent bars).
2nd bar: Causes play-
back to start from
measure 2 of the
selected Standard MIDI
File.
1st note: This is basi-
cally the same as the
above, except that
playback starts on the
first note of the
selected song.
At the end of the cur-
rent song, the next
song in the Perfor-
mance List starts auto-
matically. If the
Performance List step
refers to a Music Style,
the Style in question is
loaded, but you will
need to start manually
by pressing the [START/
STOP] button.
Allows you to set the
recording level for
your own perfor-
mances (see p. 46). The
setting of the [VOL-
UME] knob does not
affect the recording
level. (Default setting:
+0dB)
Off: Choose this set-
ting when you want to
start recording before
starting Music Style or
song playback.
On: Choose this set-
ting when you want to
be able to start record-
ing simultaneously
with Music Style song
playback. When you
choose this setting,
pressing the [AUDIO
REC] button will stop
both playback and the
recorder.
Parameter Setting
USB Driver Generic,
Original
Audio In Center Off, On
Canc
Audio in Off, On
Transpose
Auto Power Off Off, 240 min
Version Info n.nn
Pedal
The "Footswitch" setting is found on the display page
that can be selected using [MENU] button‰ "Global"
‰ "Pedal".
If you do not change the factory setting, the foot-
switch is assigned to the Start/Stop function.
The following table shows the functions you can
assign to the footswitch.
Function Explanation
Start/Stop Starts and stops Music Style or song
playback. Same function as the
[START/STOP] button.
Explanation
Generic: Choose this if
you want to use the
standard USB driver
that was included with
your computer. Nor-
mally, you should use
this mode.
Original: Choose this
if you want to use a
USB driver down-
loaded from the
Roland website
(www.roland.com).
Select "On" if the "Cen-
ter Cancel" function
(see p. 38) should also
affect the signals
received via the AUDIO
INPUT sockets.
Select "On" if the
transposition setting
should also affect the
signals received via the
AUDIO INPUT sockets.
This parameter allows
you to cause the
BK-7m to switch itself
off after 240 minutes
if you are not using it.
The default setting is
"Off", meaning that the
BK-7m remains on
until you press the
[POWER] switch again.
Shows the version
number of the BK-7m's
operating system.