Table of Contents
Advertisement
DEVICE OPERATION
To restart the machine (soft-reset):
1)
Click RESTART.
2)
Click OK in the prompt. The system will perform a soft-reset and load to a live split-screen view.
To upgrade firmware:
1)
Copy the firmware file to an empty USB flash drive. The firmware file should not be in a folder.
2)
Connect the USB flash drive to the top USB port on the front panel of your system.
3)
Open the System Menu (Main Menu>Advance>System).
4)
Click FIRMWARE UPDATE. The system will scan the USB flash drive and begin updating the firmware. Do not
remove the USB flash drive while the upgrade is taking place.
5)
Click CLOSE in the confirmation window. In the system prompt, click OK. The system will restart.
17.
PTZ
Use the PTZ Setup menu to configure settings for a connected PTZ camera (not included).
NOTE: Consult the instruction manual of your PTZ camera for complete information about your camera, including
protocol and baud rate.
Figure 3.5.33
Figure 3.5.34
33 |
P a g e
Model #: QS218
Advertisement
Table of Contents
