NETGEAR ProSafe FR328S Quick Installation Manual

ProSafe Firewall w/Dial Back-up Port FR328S

Quick Installation Guide

Follow these quick steps to install your firewall.
Before you begin, be sure you have the configuration
parameters from your ISP handy.
1
1 Connect the Firewall
a. Turn off your computer and Cable or DSL Modem.
b. Disconnect the Ethernet cable (A) from your computer which
connects to your Cable or DSL Modem.
A
Cable or DSL modem
c. Connect the Ethernet cable (A) from your Cable or DSL Modem
to the FR328S firewall's Internet port.
Cable or DSL
modem
LOCAL
10/100M
A
MODEM 8 7 6 5 4 3 2 1 INTERNET 12VDC O.5A
Model FR328S ProSafe Firewall
d. Connect the Ethernet cable (B) which came with the firewall
from a Local port on the router to your computer.
Cable or DSL
B
modem
LOCAL
10/100M
A
MODEM 8 7 6 5 4 3 2 1 INTERNET 12VDC O.5A
Model FR328S ProSafe Firewall
e. Turn on the Cable or DSL Modem and wait about 30
seconds for the lights to stop blinking.
2
2
Log In to the Firewall
Note: To connect to the firewall, your computer needs to be config-
ured to obtain an IP address automatically via DHCP. If you need
instructions on how to do this, please refer to the Reference
Manual on the CD which came with your firewall.
a. Turn on the firewall and wait for the test light to stop blinking.
b. Now, turn on your computer and use a browser like Internet
Explorer or Netscape to connect to http://192.168.0.1
Note: If you usually run software to log in to your Internet
connection, do not run that software.
c. For security reasons, the firewall has its own user name and pass
word. When prompted, enter for the firewall User Name
admin
and for the firewall Password, both in lower case letters.
password
Note: The user name and password are not the same as
any user name and password you may use to log in to
your Internet connection.
3
3 Connect to the Internet
a. You are now connected to the firewall. Click the
the Setup Wizard.
b. Click to follow the steps in the Setup Wizard to input the
Next
configuration parameters from your ISP to connect to the Internet.
Note: If you were unable to connect, please refer to the
Troubleshooting Chapter in the Reference Manual on the
CD which came with the firewall.
button in
Yes