NETGEAR FR328S Reference Manual page 86

FR328S Cable/DSL ProSafe Firewall with Dial Back-Up
Select Private if you want to limit access to the LAN only.
d.
The static route will not be reported in RIP.
Type the Destination IP Address of the final destination.
e.
Type the IP Subnet Mask for this destination.
f.
If the destination is a single host, type 255.255.255.255.
Type the Gateway IP Address, which must be a router on the same LAN segment as the
g.
firewall.
Type a number between 1 and 15 as the Metric value.
h.
This represents the number of routers between your network and the destination. Usually,
a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
Click Apply to have the static route entered into the table.
4.
5-10 Advanced Configuration