Verifying Tcp/Ip Properties For Macintosh Computers - NETGEAR MR814 Reference Manual
Wireless router
Hide thumbs
Also See for MR814:
- Setup manual (38 pages) ,
- Installation manual (20 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Reference Manual for the Model MR814 Wireless Router
Verifying TCP/IP Properties for Macintosh Computers
After your Macintosh is configured and has rebooted, you can check the TCP/IP configuration by
returning to the TCP/IP Control Panel. From the Apple menu, select Control Panels, then TCP/IP.
The panel is updated to show your settings, which should match the values below if you are using
the default TCP/IP settings that NETGEAR recommends:
•
The IP Address is between 192.168.0.2 and 192.168.0.254
•
The Subnet mask is 255.255.255.0
•
The Router address is 192.168.0.1
If you do not see these values, you may need to restart your Macintosh or you may need to switch
the "Configure" setting to a different option, then back again to "Using DHCP Server".
3-8
Preparing Your Network
Advertisement
Table of Contents
Troubleshooting
