Clearing Hardware Option Conflicts And Saving Option Rom Space - IBM 6225 User Manual

Complete the following steps to set the CMOS recovery jumper and erase a
forgotten password:
10. Turn on the computer. The Configuration/Setup Utility program starts.
11. Follow the instructions to erase the existing password or create a new
12. Select Save Settings and press Enter.

Clearing hardware option conflicts and saving option ROM space

This section provides information about clearing hardware option conflicts and
saving option ROM space on your computer. Do not disable this jumper if you plan
to install FireWire devices on your computer.
Complete the following steps to set the IEEE 1394 (FireWire) enable/disable jumper
and clear hardware option conflicts or to save option ROM space:
1. Read the safety information beginning on page vii and "Handling static-sensitive
2. Turn off the computer and all attached devices.
3. Disconnect the power cord.
4. Remove the side cover.
5. Locate the IEEE 1394 (FIreWire) enable/disable jumper on the system board.
6. Move the IEEE 1394 (FireWire) enable/disable jumper from pins 1 and 2 to pins
7. Replace any adapters that were removed; then, replace the side cover.
8. Connect the computer to a power source, keyboard, monitor, and mouse.
9. Turn on the computer.
86
IBM IntelliStation M Pro Types 6225 and 6228: User's Guide
1. Read the safety information beginning on page vii and "Handling
static-sensitive devices" on page 29.
2. Turn off the computer and all attached devices.
3. Disconnect the power cord.
4. Remove the side cover.
5. Locate the CMOS recovery jumper (JBAT1) on the system board, removing
any adapters that impede access to the jumper. An illustration showing the
location of the jumper on the system board is in "Recovering from a
POST/BIOS update failure" on page 84.
6. Move the CMOS recovery jumper from pins 1 and 2 to pins 2 and 3.
7. Wait 60 seconds; then, return the CMOS recovery jumper to pins 1 and 2.
8. Replace any adapters that were removed; then, replace the side cover.
You can now start the computer one time and start the Configuration/Setup
Utility program without having to use the power-on password. At this time, you
can either delete the old password or set a new user password. If you do not
change or delete the password, the next time you start the computer the
original user password will be reinstated.
9. Connect the computer to a power source, keyboard, monitor, and mouse.
password.
devices" on page 29.
Remove any adapters that impede access to the jumper. An illustration showing
the location of the jumper on the system board is in "Recovering from a
POST/BIOS update failure" on page 84.
2 and 3 to set it to disabled. The default is enabled.