What tools are needed for installation?
Pipe Wrench
Adjustable Wrench
Drill
Tape Measure
10" x 5/16" Nut Driver
Thread Sealant
Level
2-1/2" Diameter Hole Saw for 2" pipe
2" Diameter Hole Saw for 1-1/2" pipe
1" Diameter Hole Saw
Non-corrosive Leak Check Solution
Where will the wall furnace be installed?
•
On the Floor - Wall Furnace comes equipped from
factory for this option. See Page 21.
•
Wall Mounted - Wall mount shroud needed. See
Page 15 for kit number.
•
Mount wall furnace at a height so that the con-
trols can still be observed.
•
Interior Wall - Maximum vent length is 50 feet.
•
Exterior Wall
•
Locate Electrical Supply - Extension cords may
NOT be used.
•
Wall Furnace Dimensions page 16.
•
Clearances to Combustibles page 17.
What kind of venting application will be used?
•
Single Flue - Wall Furnace comes equipped from
factory for this option. A 2" or 1-1/2" pipe may be
used. If a 1-1/2" pipe is used, it must be enlarged to
a 2" pipe prior to exiting the wall into the shroud.
•
Direct Vent - An "Air Pipe Kit" is required and is
available for order. See page 15.
How will the venting be run?
•
Straight out the back - Wall Furnace comes
equipped from factory for this option. Standard Rear
Shroud supplied. See page 26.
•
In Front of the wall - Deep Shroud needed. Venting
option may NOT be done in Wall Mount installations.
See page 15 for kit number.
•
Venting Guidelines pages 24 to 31.
•
Maximum vent length is 50 feet.
How will the condensate be disposed?
To a drain - Wall Furnace comes equipped from the
•
factory to drain up to 3 feet away from the appliance.
•
An Extension Kit and External Condensate Pump
kit may also be used. See page 15 for kit numbers.
•
Humidification - Optional Heated Humidification Tray
Kit available for order. See page 15 for kit number.
•
Winterization information on page 39.
Page 14
INTRODUCTION
FAQ - INSTALLATION CONSIDERATIONS
How will the wall furnace be operated?
•
Remote - external thermostat, wall switch or remote
control. See page 15 for kits available from Empire
Comfort Systems.
•
Manual - use the display panel to control the heating
level and turn the wall furnace on and off.
•
Local (Internal Thermostatic) - Factory installed
temperature probe on the wall furnace with a built-
in thermostatic function to control the wall furnace's
operation.
•
If it is desired to use the temperature sensed in
another part of the room, a wired temperature
probe accessory kit is available. See page 15 for
kit numbers.
•
See Operation Instructions pages 7 to 12.
32084-1-0713