Accessories - Empire Heating Systems PVS18(N,P)-1 Owner's Manual And Installation Instructions

VENTING
Part Number Description
PVSA1 Air Pipe Kit
PVSDV35A DV35 Vent Transition Cap
SHROUDS
Part Number Description
PVSDS1 Deep Rear Shroud
PVSWS1 Wall Mount Shroud
CONDENSATE KITS
Part Number Description
PVSHT1 Heated Humidification Tray
PVSEP1 External Condensate Pump
PVSCT10 Condensate Hose Extension
CONTROLS
Part Number Description
PVSRT1 Wired Remote Temperature Sensor
FRBTPL Wireless Remote Thermostat
Important
All correspondence regarding repair and service should refer to
complete Model Number, Serial Number and type of gas.
Removing the Front Panel
It may become necessary to remove the front panel of the appli-
ance to remove dropped or fallen objects.
Remove the front panel by lifting up then pulling out. Replace the
panel by reversing this step.
WARNING
FOR YOUR SAFETY, TURN OFF POWER TO APPLIANCE.
WARNING
Do not operate this appliance without the front panel.
32084-1-0713
INTRODUCTION

ACCESSORIES

ACCESSORIES
Typical Uses
Converts wall furnace from single flue to direct-vent
Replaces DV35 Vent cap with a transition to PVC pipe for a 2" single flue.
Typical Uses
Allows venting to be run in front of the wall in on the floor installations
Allows installation of wall furnace off of the floor
Typical Uses
Evaporates condensate as humidity back into the room
Pumps condensate away from wall furnace instead of gravity drain
10 ft condensate drain extension
Features
Room Temperature Sensor Extension
Manual or Thermostatic Operation, Modulating, 10 Preset Weekly Programs
Page 15