Toshiba Portege M750 User Manual page 89

8. Seat the memory module cover in place and secure it with one screw.
Take care to ensure that the memory module cover is firmly closed.
Memory module
cover
9. Install the battery pack - refer to
Chapter 6, Power and Power-Up Modes, if required.
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Removing a memory module (Slot B)
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
Always make sure the display panel is closed in Laptop mode before
turning the computer upside down.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
7. Push the latches away from the module in order to release it - a spring
will force one end of the module up at an angle.
User's Manual
Screw
Figure 3-17 Seating the memory module cover
Hardware, Utilities and Options
Replacing the battery pack
Turning off the power
section in Chapter 6, Power and Power-Up
section in
section in
3-34