System Bypass - Apex Digital DESTINY 6100 SERIES Owner's Manual

To BYPASS a zone is to temporarily remove that zone from the
system. To enter BYPASS mode, your system must be disarmed.
Make sure the system is disarmed and follow the steps below:
1. Enter your disarm code and immediately press the 9 key to gain entry
into BYPASS mode. You will hear "BYPASS MODE, ENTER ZONE
NUMBER."
2. Enter the two digit number of the zone (use a leading zero if necessary,
01,02...) you wish to bypass. (Your installer can provide you with a zone
list, if needed). You will hear a description of the selected zone, followed
by, BYPASSED ON or OFF. Only zones that exist in the system can be
bypassed. If an invalid number is entered, refusal will be signaled by
three beeps.
3. Press the * or A key to toggle between on and off. (A "BYPASSED ON"
condition indicates that the zone is bypassed). The yellow STATUS LED
will light to indicate that the zone is bypassed. The RKLCD keypad will
display the zone descriptor in the LCD display. A second push of the * or
A key within 10 seconds will remove the zone from bypass and the yellow
STATUS LED will clear as well as the zone descriptor on the LCD
display.
4. Pressing 00 while in BYPASS mode will clear (unbypass) all bypassed
zones.
5. Press the # or H key to exit BYPASS mode, or the system will exit in 5
seconds. You will hear the system speak "EXIT".
EXAMPLE:
Assuming primary code is 1,2,3,4, and zone number 1 is the front
door:
Enter 1,2,3,4 & 9
"BYPASS MODE, ENTER ZONE NUMBER"
Enter 01 (Zone number one)
"FRONT DOOR BYPASS OFF" (Currently not bypassed)
Press * or A key to turn zone bypass ON
"FRONT DOOR BYPASS ON" (Zone is now bypassed)
Press # or H; system will speak EXIT.
Zone one is now bypassed. This gives you the ability to have the
system armed but open and close the front door without setting off
the BURGLAR alarm. Follow the same steps to remove that door
from the bypass mode and return it to normal activation.

System Bypass

13