GE ZDP484NG Installation Instructions Manual page 23

Installation Instructions for Gas Conversion
[_ CHANGE GRIDDLE ORIFICE
(if present}
Locatethe 3/4" long griddle orifice.
Selectfor your gas type. LP--.047, NAT--.076 I t
A. Lift off the
B.
C.
D.
E.
griddle flue
cover. Remove
the 2 inside
clamping
screws.
Lift out the
cast-iron
grease trough.
Slide the
griddle toward
the rear end
out of the
hold-down
tabs along the
bottom.
Carefully lift and hold
the griddle while pulling
additional length of the
capillary from the entry
hole. Stand the griddle on
end in the grease sump.
Remove the 2 hold-down
screws at the rear of the
burner.
Pull the burner straight
buck toward the rear and
out of the gas inlet.
Use a 1/2" deepwell
socket to remove and
replace the orifice.
GriddleFlueCover
A
/
NOTE: Remove
2 screws
_ositioned on
insideonly.
Donot remove
the outermost
screws--they
arefor leveling.
Capillary
B Backof Range E Frontof Range
Reverse these steps to reassemble the griddle.
Push excess capillary back into the entry hole.
Place the unused orifice in the holder for possible
future use.
[_ ADJUST BURNER FLAMES
Normally, burners do not need further adjustment.
Hake adjustments only when necessary.
A. Turn on the gas. Plug in electrical cord.
B. Turn all burners on highest setting and check
the flames. They should be blue in color. When
using LPgas, the flames may hove some yellow
tipping at the ends of the flame. Foreign pc_rticles
in the gas line may cause tin orange flame at first,
but this will soon disappear.
C. Turn the burner knob to "LO" while observing the
flame.
Adjust the setting of the upper row of flames using
the valve bypass screw as follows:
Adjustments must be made with two other burners
in operation on a medium setting. This prevents
the upper row of flumes from being set too low,
resulting in the flume being extinguished when
other burners are turned on.
D. To adjust the flume, remove the knobs. Insert c] small
flat-blade screwdriver into the hole in the center
of the valve stem to engage screw.
• If the flames (Ire too small or flutter,
turn the screw counterclockwise.
• If the flumes are too large, turn the screw
clockwise.
E. Make the adjustment by slowly turning the screw
until flame (_ppec_rance is correct.
I m
! Once the conversion iscomplete end checked, fill out the conversion label end affix the label near the rating label. For ranges,
place the label beneath the control panel. For rongetops, place the label on the bottom of the unit.
23