GE ZDP484NG Installation Instructions Manual page 18

Z×12B30PSS,Z×12B36PSS,Z×12B48PSS AccessorgInstallation
OPTIONAL ACCESSORIES--12" HIGH BACKSPLASH
WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected bg a backsplash constructed
of non-combustible material.
This stainless steel backsplash accessorg
must be installed in combination with a custom,
non-combustible backsplash built begond
the 12" height of the backsplash.
BEFORE YOU BEGIN
Reed these instructions completelg
end cerefullg.
IMPORTANT: Sere these instructions for Iocel
inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leeve these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with gour Owner's Menuel for future reference.
This kit provides for the instelletion of e 12" high
becksplesh for 30", 36" or 48" Monogrem
Professional Ranges end Rongetops.
• Pencil
This Kit Includes
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-15 and #2 Phillips screwdrivers Wall Support
Drill with :3/32" and 9/64" bits Panel
• SafetgLevel glasses
• Wall support panel
• Cover panel
• Hardware package with
- 5 Stainless Steel Torx 15 #8
self-tapping screws
- 5 Phillips #2 pan head wood
#10 screws
Hardware
Package
INSTALL 12" BACKSPLASH
-AWARNING: This becksplesh must
be securely fastened to the well. Failure to do
so could result in damage or personal injurg.
• Install and level the range or rangetop and the
range hood according to the installation
instructions.
• Remove the backsplash packaging and
protective film.
• Use a level to pencil o horizontal line on the wall,
1/8" above the range or rongetop. The 1/8" gap
allows the cover panel to overlap the wall support
panel.
• Locate wall studs on each side. Where studs ore not
available, plan to use wall anchors (not provided).
• Align the wall support panel on the marked
horizontal line and centered left to right.
• The wall support panel must be secured to the wall
at oil 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
• Place the cover panel over the wall support
panel and secure with Torx screws (provided).
Install 2 screws on each side.
Install4 Wood
Screws
Wall Support
Panel
Wall
Support
Panel
CoverPanel
.... _ InstallT-15
o_ Screws
18