GE Monogram ZIK30GNZAII Design & Installation Manual page 12

Installation instructions
TOOLS REQUIRED
.5/:32" Allen wrench
Utility knife
. Stepladder
. Bucket
. Level
. Appliance hand truck
. Tubing cutter
.7/16" open-end wrench
.1-5/16"
open-end wrench
. #2 Phillips screwdriver
. Drill and bit set
.5/16" socket
. Safety glasses
. Pliers
.5/8" ratchet
. Torx T-20, T-Z0 wrench
HARDWARE SUPPLIED
. Anti-tip bracket & screws
. Panel mounting brackets
. Door panel templates- Pub # 31-46543
. Water filter - Part # GSWF
. Drywall Anchors and screws
MATERIALS REQUIRED
.1/4" copper water line tubing or GE SmartConnect TM
Refrigerator Tubing kits
. Water shut-off valve
. Custom panels for fresh food door, freezer drawer
and Convertible drawer
. Velcro w/adhesive if using custom toekick.
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is at
the same height as the rest of the flooring. This
surface should be strong enough to support (] fully
loaded refrigerator, or approximately 1,200 Ibs.
NOTE: Protect the finish of the flooring. Cut u large
section of the cardboard carton and place under
the refrigerator where you are working.
12