Jp4: Usb Device Wake Up Selection - Gigabyte 6VMM User Manual

JP4: USB Device Wake up Selection

Please Note
to set the BIOS setting "USB KB/MS Wake up from S3" enabled,
& JP9" enabled).
*(Power on the computer and as soon as memory counting starts, press <Del>. You will
enter BIOS Setup. Select the item "POWER MANAGEMENT SETUP", then select
"USB KB/MS Wake up from S3". Remember to save the setting by pressing
"ESC" and choose the "SAVE & EXIT SETUP" option.)
JP5/JP6/JP7: Onboard AC97& AMR (Primary or Secondary) Select
(AMRà à Audio Modem Riser)
Please note:
JP7: 1 -2 close: If you use software audio(onboard CODEC only), your modem riser must
be "Secondary". JP7: 2-3 close: If you don't use onboard software audio, your
audio/modem riser must be "Primary". Mainboard's software audio will be disabled.
There are two types of AMR/MR card in the market, Primary and
secondary. If your AMR/MR card is primary, JP7 should be set to 2-3, if
you have secondary AMR/MR card JP7 should be set to 1-2. Warning! If
Primary AMR/RM card is used, on-board audio will be disabled.
1
Normal
(Default)
Pin No.
1-2 close Normal (Default)
2-3 close USB Wake Up
: (If you want to use "USB KB/MS Wake up from S3" function, you have
1
1
Jumper
Function
Only AC97
(Default)
Only AMR
(Primary)
AC97+MR
(Secondary)
32
Panel and Jumper Definition
1
Enable
Definition
1
JP7
JP6
JP5
JP5 JP6
1-2 1-2
3-4 3-4
1-2
1-2
3-4
JP4
JP7
1-2
2-3
1-2