Advertisement
Available languages
Available languages
• A riskoftip-over m ayexistif theappliance isnotinstalled inaccordance with
theseinstructions.
• Ifthe range is pulled awayfromthewallforcleaning, service, o r anyotherrea-
son,ensure thattheAnti-Tip Device is properly r eengaged w hentherangeis
pushed backagainst thewall.Intheevent o fabnormal usage (suchasa person
standing, sitting, o rleaning onanopendoor), f ailure totakethisprecaution c ould
result i ntipping oftherange. P ersonal injury might r esult f romspilled hotliquids or
fromtherange itself.
1. Adjust h eight o frange andlevel b yrotating theadjustable l egsupports o nthe
bottom oftherange, u sing1-1/4" ( 31.75 mm)wrench.
drawer
adjustable leg
Figure 19: Adjusting the Leg Support
2.
Measure to locate bracket position as shown below.
rearwall
cabinet
wall
1 9/16" (39.7 mm)
from rear wall to center of screw hole
floor
anti-tippin g
device
flush against
cabinetwall
Figure 20: Anti-tip Bracket Location
7) Complete the installation
3.
Secure bracket with 2 screws adequate for mounting surface, not included.
(i.e.; for wood floor use wood screws for concrete floor use concrete anchors
and screws).
1.
Move range close enough to the opening to plug into the receptacle.
2.
Slide range into position ensuring that the left back leg slides under the anti-
tip bracket. Range will sit 314" (19.05 mm) away from back wall when properly
installed.
3.
Carefully tip range forward to ensure that the anti tip bracket engages the
range back brace and prevents tip-over.
4.
Turn on electrical power. Check range for proper operation as described in
Use and Care Manual.
English 13
Advertisement
Chapters
